Table of Contents
Advertisement
X10QBL-4CT/X10QBL-4 User's Manual
RAID to configure a SATA drive specified by the user as a RAID drive. The options
are IDE, AHCI, and RAID.
*If the item above "Configure SATA as" is set to AHCI, the following items
will display:
SATA Port 0~ Port 5
This item displays the information detected on the installed SATA drive on the
particular SATA port.
•
Display of drive number and capacity as detected by the BIOS
Port 0~ Port 5
Select Enabled to enable a SATA port specified by the user. The options are
Disabled and Enabled.
Port 0 ~ Port 5 Hot Plug
This feature designates the port specified for hot plugging. Set this item to En-
abled for hot-plugging support, which will allow the user to replace a SATA disk
drive without shutting down the system. The options are Enabled and Disabled.
Port 0 ~ Port 5 Spin Up Device
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the
device. The options are Enabled and Disabled.
*If the item above "Configure SATA as" is set to IDE, the following items
will display:
Serial ATA Port 0~ Port 5
This item indicates that a SATA port specified by the user is not installed or not
present.
•
Display of drive number and capacity as detected by the BIOS
*If the item above "Configure SATA as" is set to RAID, the following items
will display:
SATA RAID Option ROM Type
Use this item to select the device type for onboard SATA RAID Option ROM for
system boot. The options are EFI and Legacy.
Serial ATA Port 0~ Port 5
This item displays the information detected on the installed SATA drives on the
particular SATA port.
•
Display of drive number and capacity as detected by the BIO
4-22
Advertisement
Table of Contents
