Error And Alarm Messages - Projecta INTELLI-START PJ-IS2000-2 Owner's Manual

UNDERSTANDING YOUR JUMP STARTER

ERROR AND ALARM MESSAGES

Error type Error detail
Low battery The internal battery voltage of the PJ-IS2000-2
is too low for a jump start. Please charge the
PJ-IS2000-2 immediately.
Reverse The clamps are reverse connected to the
polarity vehicle battery. The clamps should be
disconnected and reconnect in the correct
polarity.
Overvoltage The vehicle battery voltage is too high for a 12V
DC or 24V DC vehicle. Please disconnect the
clamp and ask a qualified mechanic to check
the vehicle's alternator.
Jump starter The PJ-IS2000-2 will display the "CHARGER
timeout TIMEOUT" screen if the charging cycle cannot
be completed in 24 hours.
Short circuit The PJ-IS2000-2 detected the clamps are short-
circuited. The PJ-IS2000-2 will not jump start until
the short circuit is resolved. Please disconnect the
clamps and check the vehicle electrical system.
Overload The PJ-IS2000-2 detected excess current
(more than the contactor and internal battery
can handle) occurred. Jump starting will be
disabled. Please disconnect the clamps and
check the vehicle electrical system.
Failure The PJ-IS2000-2 detected a malfunction of
internal contactors or abnormal internal battery
voltage.
Low The operating temperature is too low for the
temperature PJ-IS2000-2 to perform its required functions.
**NOTE: The jump starter can be warmed up
by turning on the flood light, at the expense
of battery charge.**
High The operating temperature is too high for the
temperature PJ-IS2000-2 to perform its required functions.
Surge The jump starter has detected surge protection
protection system failed. User is advised to contact
failure customer service.
10
Error display
CHARGING CHARGING
NOT POSSIBLE
NOT POSSIBLE
35ºC 65ºC
Wait for jump starter Wait for jump starter
to warm up
to cool down
CHARGING
NOT POSSIBLE
35ºC
Wait for jump starter Wait for jump starter
to warm up
LOW BATTERY
Charge jump starter
OVERVOLTAGE
DETECTED
30.1V
Disconnect clamps
CHARGING
NOT POSSIBLE
35ºC
Wait for jump starter
to warm up
USB DISABLED
65ºC
Wait for jump starter
to cool down
CHARGING
USB DISABLED
NOT POSSIBLE
65ºC
65ºC
Wait for jump starter
to cool down to cool down
CHARGING
NOT POSSIBLE
65ºC
Wait for jump starter
to cool down