Usb Output - Projecta INTELLI-START PJ-IS2000-2 Owner's Manual

USB OUTPUT

The USB output allows the user to charge external compatible devices.
Step Detail
1 If the PJ-IS2000-2 is not in jump starting operation, and the user connects an external
device to charge the following screen will be displayed.
Note: The USB output will be automatically disabled in the following conditions:
• PJ-IS2000-2 is turned off
• Once USB device is fully charged
• Exit mode
• Jump start mode
• Error mode
• Rapid Recharge (RRT
• Low battery condition
• Battery temperature below -4°F (-20°C) or above 140°F (60°C), or ambient temperate
above 113°F (45°C)
CHARGING
Step Detail
1 Plug the output of the AC charging dock into a 110V AC socket. Once
the AC dock is plugged into a 110V AC source, you can place the
PJ-IS2000-2 onto the charging dock. Alternatively, plug a USB-C cable
into the USB-C port on the PJ-IS2000-2 to begin charging the jump
starter.
**Using a non-supplied charger and USB cable may extend charge
time.**
2 The battery charging screen will be shown when the PJ-IS2000-2 is
being charged either by the 110V AC dock or USB-C socket plugged in.
3 When the PJ-IS2000-2 is fully charged, it will display "CHARGING
COMPLETE".
4 The PJ-IS2000-2 will display the "CHARGER TIMEOUT" screen if the
charging cycle cannot be completed in 24 hours. The typical charging
time is 4 hours if the battery is at 50% state of charge.
Note: It is recommended to fully charge the PJ-IS2000-2 before the first use, as the PJ-IS2000-2 is shipped only
partially charged.
) mode
®
Display
Display
CHARGING
COMPLETE
9