Important Charging Information - Projecta INTELLI-START PJ-IS2000-2 Owner's Manual

IMPORTANT CHARGING INFORMATION

• Charge the jump starter prior to use, using the supplied USB charger or dock. This may
take up to 8 hours.
• Fully recharge the jump starter after every use to ensure your jump starter is ready for use
in case of an emergency.
• Do not allow the jump starter battery to become very flat. If the display shows 'Low
Battery' ensure the jump starter is charged immediately to ensure the maximum battery
life. Refer to "ERROR AND ALARM MESSAGES" section (page 10).
• The jump starter has a USB-C charging port. This allows the user to charge the jump starter
using a USB-C cable (5V DC, 3A).
• Always use the USB-C cable and chargers that are provided with the unit.
• To extend the life of your jump starter do not let the battery charge level fall below 1 bar.
• To extend the life of the jump starter battery, do not charge in an environment above 113°F
(45˚C) or below 32°F (0˚C).
FEATURES
RAPID RECHARGE TECHNOLOGY (RRT)
• The Lithium Iron Phosphate (LiFeP04) battery can rapidly recover charge from the vehicle's
alternator following a successful jump start. Leaving the clamps connected to the vehicle's
battery for 40 seconds will recharge the jump starter to 100%
status. If left connected, will recharge for up to 10 minutes. Once the jump starter is fully
charged, the RRT will shut off avoiding overcharging.
LITHIUM SAFE
• Intelli-Start Lithium Iron Phosphate (LiFePO
cranking therefore purpose built for jump starting and are safer than Lithium Cobalt
(LiCo02) battery types. The LiFeP04 batteries provide more starts and have an operational
life of up to 2000 battery cycles.
JUMP STARTING PERFORMANCE
• This PJ-IS2000-2 iis suitable for starting vehicles with up to 10 cylinder gas and 7L
diesel vehicles.
• With 40 seconds of rapid recharge after each jumpstart, the PJ-IS2000-2 will not need to be
recharged during the working day.
• It is recommended that the PJ-IS2000-2 jump starter is charged via the supplied 12-24V
DC USB socket charger and USB-C cable or 110V AC charging dock to maximise the jump
starter performance.
INTUITIVE color display
• The intuitive color display makes the PJ-IS2000-2 easy for anyone to use with step by
step instructions.
Built in LED FLOOD LIGHT
• Provides illumination for safer, more convenient operation at night.
• The flood light will timeout after 4 hours if left on. Users should take care to turn off flood
light when not used to preserve battery life.
of the original charge
1
) batteries are specifically designed for
4
3