Radio Ethernet Default Parameters; Network Connectivity Test - Ebyte E180-DTU User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
In order to avoid problems such as server search failure and inability to open web pages in the actual application process, it is
recommended to check the relevant settings of the computer first.
（1） Turn off your computer's firewall and anti-virus software；
（2） Configure the NIC to which the device is connected；
（3） This case is for the device directly connected to the computer test, you need to configure the computer as a static IP (the
computer is directly connected to the device, there is no router to assign, the computer cannot obtain the IP address), and the use of switches or
routers needs to ensure that the device and the computer are in the same network segment (for example: 192.168.3.xxx)；
（4） In this case, the static IP address of the computer is 192.168.3.4 (the same CIDR block as the device), the subnet mask is
255.255.255.0, and the default gateway is 192.168.3.1。

4.3.2 Radio Ethernet default parameters

project
IP address
Default local port
Subnet mask
Default gateway
Default working mode
Serial port baud rate
Serial port parameters

4.3.3 Network connectivity test

After the above operation steps, follow the factory default parameters of the device and perform the following operations to achieve
network connection。
The procedure is as follows：
（1）Open the Test TCP/IP Debugging Assistant software；
（2）In the "Network Settings" area, select TCP Client Mode, the remote host address corresponds to (the default local IP
of the device: 192.168.3.7), and the remote host port corresponds to the factory port 8887 of the device, click Connect；
Copyright ©2023，成都亿佰特电子科技有限公司
Default parameters
192.168.3.7
8887
255.255.255.0
192.168.3.1
TCP Server
115200（Modification is not recommended）
8 / None / 1（Modification is not recommended）
E18-DTU(Z27-ETH) User Manual
47