Factory Default Parameters - Ebyte E95-DTU 433C 485-V2 Series Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.
Read/
06H REG3
Write
07H Write CRYPT_H
08H Write CRYPT_L

5.3 Factory Default Parameters

Model
Modem model
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology Co.,Ltd.
7 Receive packet RSSI
0 Close (default)
1 Open
6 Transmission method
0 Transparent transmission (default)
1 Fixed-point transmission
5 Relay function
0 Close (default)
1 Open
4 3 2 1
Key high byte (default 0)
Key low byte (default 0)
Restore Factory Default Parameters Command：C0 00 09 00 00 00 40 00 2E 00 00 00
Freque Signal
Address
ncy path
*
* When enabled, wireless data
* Conversion formula: dBm =
*
* When transmitting at a fixed
*
* When the relay function is
* In order to prevent data back
0 Reserve
* Write only, read returns 0;
* These two bytes will be used
Airspeed Baud rate
E95-DTU(433Cxx-485)-V2.0 User manual
For general transmission mode
only;
received by the radio and
output through the serial port
TXD will follow an RSSI
strength byte to indicate the
signal strength at the time the
data was received;
RSSI/2-146.
For general transmission mode
only;
point, the radio recognizes
the first three bytes of the
serial port data as: address
high + address low + channel,
and uses them as the wireless
transmit target.
For general transmission mode
only;
enabled, the radio will
initiate a forward if the
destination address is not the
radio itself;
propagation, it is recommended
to be used in conjunction with
fixed-point mode; i.e., the
destination address is
different from the source
address.
used for encryption to avoid
interception of over-the-air
radio data by similar
stations;
internally by the radio
station as a computational
factor to transform and
encrypt the over-the-air radio
signal.
Serial
Port
Transmit
power
19