Quickly Join A Zigbee Network - Ebyte E180-DTU User Manual

Hide thumbs Also See for E180-DTU:

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

E18-DTU(Z27-ETH) User Manual

4.4.3 Quickly join a ZigBee network

（1）Connect radio 2 to the computer, open the host computer software "ZigBee3.0 host computer", select the device type, enter the IP

address, enter the port number, click Connect to Server, and you can see that the right window shows that the connection is successful.

（2）Click "Start Network Configuration", the LINK light of the DTU device flashes rapidly at 10Hz, and it is necessary to ensure that the

coordinator device is also in the network configuration state (see Section 5.1). Wait for a while, the LINK light of the DTU turns to solid light

or 1Hz flashing (router mode), click "Read Parameters", you can view the network access information of the device, and the network status is

"connect". If the LINK lamp turns off and the network status is "not have", the module fails to add the network, check whether the coordinator

device is in the network configuration state and whether the distance between the coordinator device and the router/terminal device is within a

reasonable range.

Table of Contents