Ebyte E180-DTU User Manual page 60

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

E18-DTU(Z27-ETH) User Manual

（5）On the interface of the host computer of the coordinator, set the endpoint device to bind the router device so that the end node device

can transmit data transparency to the router device. On the host computer interface of the coordinator device, click the "Network Command"

menu, fill in the short address of the terminal device in the "Device Staging List" into the "Destination Short Address", fill in the SN number

of the terminal device into the "Source Destination SN", fill in the SN of the router device with the "Destination Virtual SN", and fill in the

cluster ID with 08 FC (Ebaite follows the ZigBee Alliance's official "ZigBee Cluster Library" specification to customize the data transmission

cluster, see the " ZigBee 3.0 Module HEX Command Standard Specification), and then click "Set Constant Connection"。

To ensure that the binding settings are valid, you can click View Frequent Connections to confirm whether the binding is successful. As

shown in the figure, there is a cluster ID 08 FC on the module, Source SN is the terminal device, and Target SN is the binding record of the

router device, indicating that the binding setting is successful。

Table of Contents