Ebyte E180-DTU User Manual page 52

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

E18-DTU(Z27-ETH) User Manual

（2）The module leaves the factory for HEX command configuration mode, click "Read parameters", the message box prompts "Read

parameters successfully", the main network parameters include: long address, the station type defaults to coordinator (if not, please set to

coordinator), network status is "not have" (if you do not need to exit the network or restore to the factory). If the read parameters are invalid, it

is possible that the module is currently in transmission mode, and you need to click "Enter Configuration Mode", and the message box

prompts "Entering the configuration state successfully"。

（3）Click "Start Network Configuration" to coordinate to establish an open network, the coordinator will open the network for 180 seconds

after creating a new network, the LINK light flashes 1Hz, and routers and terminals can join the network within this time。

Table of Contents