Udp Server Mode; Udp Client Mode - Ebyte E180-DTU User Manual

Table of Contents

Chengdu Ebyte Electronic Technology Co.,Ltd.

3.4.3 UDP server mode

UDP Server means that the device does not verify the source IP address of the data when communicating with the UDP protocol, and

after each UDP packet is received, the source IP address and source port of the packet are saved, and they are set as the destination IP and port,

so the data sent by the device only sends packets to the source IP address and port where the last time the device received data。

This mode is usually used in scenarios where multiple network devices communicate with this device at a high frequency and TCP Server

cannot meet the conditions。

Using UDP Server requires the remote UDP device to send data first, otherwise it cannot send data normally。

Note: In UDP mode, the network should send data to devices less than 512 bits per packet, otherwise data loss will result。

UDP Client A connectionless transport protocol that provides simple, transaction-oriented unreliable messaging services, with no

connection established and disconnected, and only the destination IP and destination port need to be configured to send data to each other. It is

usually used in data transmission scenarios where there is no requirement for packet loss, packets are small and sent frequently, and data is to

be transmitted to a specified IP.

E18-DTU(Z27-ETH) User Manual

Table of Contents