Ebyte E180-DTU(Z20-ETH) User Manual page 68

Chengdu Ebyte Electronic Technology Co.,Ltd.
(7) In the upper computer interface of the router device, set the target port to "00" (the target port to 0x00 is multicast mode),
then set the target short address to "01 00" (the target short address is multicast address, here to group 0x0001 group), click Set,
and the router sends a transmission message to group 0x0001 multicast. Then click "Enter Transmission Mode".
Through the above configuration, the router device and the terminal device can transmit data to each other, and the
coordinator no longer receives the data transmitted by them. The coordinator can add more devices and set them up to
communicate with each other.
(8) Open the network debugging assistant, select the protocol type as "TCP Client", enter the IP address, enter the remote
host port, and click Connect.
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology
Co.,Ltd.
Technology Co., LTD
E180-DTU(Z20-ETH) User Manual
68