Ebyte E180-DTU(Z20-ETH) User Manual page 65

Chengdu Ebyte Electronic Technology Co.,Ltd.
(1) Click "Enter the Parameter Configuration" in the upper computer interface, and the coordinator devices and router devices
will return to the configuration mode. When the coordinator returns to configuration mode.
(2) The coordinator will add several network access nodes, set a new device as "terminal node", click "write parameters" and
"restart", and add the terminal node device to the coordinator device network (see Section 4.4.3).
(3) The new node device is successfully configured to enter the network. Click "Read parameters" to check the network status as
"connect", indicating that the terminal node device has joined the coordinator device network.
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology
Co.,Ltd.
Technology Co., LTD
Coordinator equipment, and the router equipment
E180-DTU(Z20-ETH) User Manual
65