Ebyte E180-DTU(Z20-ETH) User Manual page 63

Chengdu Ebyte Electronic Technology Co.,Ltd.
(4) Enter the transmission mode. After clicking "Enter transmission mode" on the upper computer interface of the coordinator
device and the router device respectively, both can enter the transmission mode. One side serial port input any data, the other
side serial port can completely output the same data.
After entering the transmission mode, close the host computer configuration software and open the serial port assistant. If
either party enters any data, the other party will output the same data. The party sending the data returns "OK" for sending
success, and "FAIL" or "ERRO" for sending failure.
(5) Open the network debugging assistant, select the protocol type as "TCP Client", enter the IP address, input the remote
host port, and click Connect.
Copyright ©2012–2023，Chengdu Ebyte Electronic Technology
Co.,Ltd.
Technology Co., LTD
Coordinator equipment, and the router equipment
E180-DTU(Z20-ETH) User Manual
63