SATO Argox XM4 Series User Manual page 41

XM4 Series Printer
User Manual
Item No. Sub Item
10 PEELER INSTALLED
Factory Default: NO
➢ Advance
Item No. Sub Item
Setting
Advance
MEDIASENSOR
11
TYPE
Factory Default: SEE-THROUGH
Remark: To select for different media types. after changing the sensor setting, make sure to calibrate
before printing. (Restart printer after changing the settings.)
CALIBRATION
12
MODE
Factory Default: INTELLI PRINT
Remark: In INTELLI PRINT mode, just install labels, latch print module, press the FEED button once, and
then the printer will feed 1-2 labels to detect next gap / black mark before printing. In SMART PRINT
mode, print immediately from the first label according to the label length setting. Make sure to carefully
align label bottom edge at the tear-off position before printing. Restart printer after changing the settings.
Value Enter key
NO
Enter
YES
Value
REFLECTIVE
SEE-THROUGH
INTELLI PRINT
SMART PRINT
MANUAL PRINT
36
Select Key Back Key
Enter/Right Up/Down
Enter
Enter key Select Key Back Key
Enter/Right Up/Down
Enter/Right Up/Down
Enter/Right Up/Down
Enter/Right Left/Right
Enter/Right Up/Down
Enter/Right Left/Right
Back/Left
Back
Back/Left
Back/Left
Back/Left
Back
Back/Left
Back