The model and serial numbers will be found on a decal attached to the pressure washer. You should record both serial number and date of purchase and keep in a safe place for future reference. Hotsy EP • 8.914-444.0 • Rev. 07/13...
(GFCI). If rated more than 250 volts, or more than single phase this product should only be connected to a power supply receptacle protected by a GFCI. Hotsy EP • 8.914-444.0 • Rev. 07/13...
PROTECT FROM specifi ed in the manual. FREEZING cause malfunction of the machine and result in death, serious bodily injury, and/or property damage. Fol- low storage instructions specifi ed in this manual. Hotsy EP • 8.914-444.0 • Rev. 07/13...
fl oor. This system prevents internal pump dam- High Pressure Hose — Connect one end to water age. pump discharge nipple and the other end to spray gun. Hotsy EP • 8.914-444.0 • Rev. 07/13...
Pump Water Inlet Garden Hose STEP 10: Connect the garden hose to pump water inlet. Inspect inlets. CAUTION: Do not run the pump without water or pump damage will result. Hotsy EP • 8.914-444.0 • Rev. 07/13...
NOTE: For a more gentle rinse, select the white 40° or green 25° nozzle. To scour the surface, select the yellow 15° or red 0° nozzle. To apply de- tergent select the black nozzle. Hotsy EP • 8.914-444.0 • Rev. 07/13...
Select and install the washer in low pressure for 1-2 minutes. desired high pressure nozzle. NOTE: You can also stop detergent from fl owing by simply removing detergent siphon tube from bottle. Hotsy EP • 8.914-444.0 • Rev. 07/13...
2. Restart pressure washer and let it run briefl y (about 5 seconds) until water no longer discharges from the high pressure outlet. Hotsy EP • 8.914-444.0 • Rev. 07/13...
MOTOR STOPS Check that main voltage corresponds to the speci- Tripped thermal overload due to over- fi cations. Wait a few minutes before turning on the heating machine again by resetting the GFCI cord. Hotsy EP • 8.914-444.0 • Rev. 07/13...
Check pump oil and engine oil level before fi rst use of your new pressure washer. Estimated Operating Estimated Operating Date Oil Changed Date Oil Changed Hours Since Last Hours Since Last Month/Day/Year Month/Day/Year Oil Change Oil Change Hotsy EP • 8.914-444.0 • Rev. 07/13...
Kit B 9.104-039.0 Outlet Kit O-Ring 12 ID x 2 CS A, D Kit C 9.104-040.0 Stem Basic Kit O-Ring 6 ID X 2 CS A, D Kit D 8.920-045.0 UU1 Complete Stem Kit Hotsy EP • 8.914-444.0 • Rev. 07/13...
Clamp, Hose, .46 - .54 ST 9.802-223.0 Spray Gun, Shut-Off 9.802-251.0 Tube, 1/2" x 1/2" Clear Vinyl 6ft. 9.802-220.0 Wand, Straight 8.707-057.0 Strainer, 1/4" Hose Barb, Plastic Nozzle, See Specifi cations Page ▲ Not Shown Hotsy EP • 8.914-444.0 • Rev. 07/13...
Page 22
Hotsy does not authorize any other party, including authorized Hotsy Distributors, to make any representation or promise on behalf of Hotsy, or to modify the terms, conditions, or limitations in any way. It is the buyer’s responsibility to ensure that the installation and use of Hotsy products conforms to local codes.
Page 23
If you need service on your pressure washer, contact your local Hotsy dealer or visit www.Hotsy.com. Smart phone users scan the code below to link directly to the Service Request page. Form # 8.914-444.0 • Rev. 07/13 • Printed in U.S.A. by Hotsy...