Installation; Installation Safety - JinkoSolar JKM565N-72HL4-V Installation Manual

to the product.

Do not clean the glass with chemicals. Only use tap water. Make sure the module surface
temperature is cool to the touch. Cleaning modules with cool water when module surface temp is
high may result in glass breakage. Do not brush paint or corrosive substances on the surface of the
modules.

Do not disconnect any of the modules when under load. If you need to disconnect the connector,
you must first close the DC and AC converter or disconnect junction box master switch.

When looking at PV modules with anti-reflection (AR) coating technology, it will be normal to see
some cells with a slight color difference at different angles. Modules with LRF(light reflective film)
and without LRF should not be built in the same array or roof.

The junction box connector should not be in contact with oily substances, organic solvents and other
corrosive materials to avoid damage to the connector. For example, alcohol, gasoline, lubricants,
rust inhibitors, herbicides and so on. If the connector is polluted, need to replace new connector to
use again.

Before the installation of modules, it is recommended to add rainproof facilities in the project site to
avoid direct open-air placement.
 The maximum altitude the PV module is designed for ≤ 2000m.
 Meaning of crossed –out wheeled dustbin:
Do not dispose of electrical appliances as unsorted municipal waste,
use separate collection facilities.
Contact your local government for information regarding the collection
systems available.
If electrical appliances are disposed of in landfills or dumps, hazardous
substances can leak into the groundwater and get into the food chain,
damaging your health and well-being.
When replacing old appliances with new ones, the retailer is legally
obligated to take back your old appliance for disposals at least free of
charge.

2. Installation

2.1 Installation Safety


Always wear protective head gear, insulating gloves and safety shoes (with rubber soles) and other
protective measures during installation.

When installing or maintaining the photovoltaic system, please do not wear metal rings, watches and
-3-