Installation; Installation Safety - JinkoSolar JKM200P-60 User Manual

 Do not clean the glass with chemicals.
 Do not disconnect any of the modules when it is under load.

2. Installation

2.1 Installation safety

 Always wear protective head gear, insulating gloves and safety shoes (with
rubber soles).
 Keep the PV module packed in the carton until installation.
 Do not touch the PV module unnecessarily during installation. The glass surface
and the frame may be hot. There is a risk of burns and electric shock.
 Do not work in rain, snow or windy conditions.
 Due to the risk of electrical shock, do not perform any work if the terminals of the
PV module are wet.
 Use insulated tools and do not use wet tools.
 When installing PV modules, do not drop any objects (e.g., PV modules or tools).
 Make sure flammable gasses are not generated or present near the installation
site.
 Insert interconnect connectors fully and correctly. Check all connections.
The interconnect cable should be securely fastened to the module frame, Cable
support should be done in a way to avoid the connector from scratching or
impacting the back sheet of the module.
 Do not touch the junction box and the end of the interconnect cables (connectors)
with bare hands during installation or under sunlight, regardless of whether the
PV module is connected to or disconnect from the system.
 Do not expose the PV module to excessive loads on the surface of the PV
module or twist the frame.
 Do not hit or put excessive load on the glass or back sheet, this may break the
cells or cause micro crack.
 During the operation, don't use sharp tools to wipe the back sheet and glass, it
would leave scratch on the module.
 Do not drill holes on the frame, it may cause corrosion of the frame.
 For roof mounting structure, when install the modules, please try to follow the
"from top to bottom" and/or "from left to right" principle, and don't step on the
module, that will damage the module and would be dangerous for personal safety
- 5 -
Rev. C