Connect Your Pc To Ethernet Port - ICP DAS USA ISaGRAF PAC Series Getting Started

3.3 Connect Your PC to Ethernet Port

The Ethernet port of the μPAC-5x07 PAC provides Modbus TCP/IP Slave protocol. It can
be used to connect to the PC or HMI software. Up to 6 PC/HMI can talk to one
μPAC-5x07 at the same time through the Ethernet port.
Before you can download an ISaGRAF application to the μPAC-5x07 PAC using the
Ethernet port, you must first setup the Ethernet port to properly communicate with the
host PC.
μPAC-5x07:
Set IP address, Mask and Gateway. Please refer to
PC:
First open an ISaGRAF project and select a program you wish to communicate between
your PC and the μPAC-5x07 PAC system. Next, click on "Link Setup" button in the
project screen as shown below.
A "PC-PLC Link Parameters" dialog box will appear as shown below. Select the
"Ethernet" communications option and click on "Setup" button.
Getting Started: PAC-5007/5107/5207/5307 Ver. 1.1, 12/2011
Industrial Ethernet Switch
NS-205/208(PSE)
PC / HMI
Ethernet
Section 3.9
μPAC-5x07
Port No. = 502
.
. 3-3
ICP DAS