ICP DAS USA ISaGRAF PAC Series Getting Started page 18

3. Click on the windows [Start] > [All Programs] > [ISaGRAF 3.x] > [Projects] to start the
ISaGRAF software.
Note1: You must install the hardware protection device (dongle) provided with the ISaGRAF
software on your computer parallel port for ISaGRAF program to achieve fully
authorized functionality.
While using ISaGRAF and the dongle is plugged, if the menu [Help] > [About] says
"Maximum number of IO variables: 32", it means ISaGRAF workbench cannot find the
dongle. Please reset your PC and then verify the [Help] > [About] again.
Note2: If it still displays "Maximum number of IO variables: 32", the dongle driver may not be
installed well. Please execute the ISaGRAF CD_ROM \Sentinel5382\setup.exe for
ISaGRAF-80, while \Sentinel\setup.exe for other ISaGRAF version and then reset the PC
again.
Note3: Since ISaGRAF 3.51, it is using USB protection-key. To make your PC recognize the
ISaGRAF USB protection-key, please un-plug the USB key from your USB port first, then
run "\Sentinel\SSD5411-32bit.exe" in the ISaGRAF 3.51 ~ 3.55 CD-ROM after you have
installed the ISaGRAF. Then you have to plug on the USB protection-key before you
executing ISaGRAF Projects every time.
Important Notice for Windows 2000 Users:
If you close some ISaGRAF windows, it holds about 20 ~ 40 seconds (No response). This
may caused by the procedure "CTFMON.EXE" of Windows 2000. To avoid this problem,
you may create a short cut for the "ISaGRAF project manager". And then verify the "run
in separate memory space" option in the shortcut property.
Getting Started: PAC-5007/5107/5207/5307 Ver. 1.1, 12/2011
2-2
2.
1.
ICP DAS