Wireless Headsets; Cisco Headset Configuration On Cisco Unified Communications Manager - Cisco 7800 Series Accessories Manual

Wireless Headsets

Wireless Headsets
You can use most wireless headsets with your phone. For a list of supported wireless headsets, see
http://www.cisco.com/c/en/us/products/unified-communications/uc_endpoints_accessories.html
Refer to your wireless headset documentation for information about connecting the headset and using the
features.
Cisco Headset Configuration on Cisco Unified Communications
Manager
The Cisco Headset 500 Series and Cisco Headset 730 is supported by most Cisco Unified Communications
Manager (Unified CM) releases. But you should install the latest phone firmware release and device packages
before connecting your headset to a phone. When the headset is first connected, it will download the required
firmware and begin the upgrade process.
The following tables list the Unified CM parameters and the phone firmware release that is required for your
Cisco headset to function.
Table 16: Cisco Headset 500 Series Headset Parameters for Cisco IP Phone 7800 Series
Cisco Headset
Cisco Headset
531 and 532
Cisco Headset
561 and 562
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
26
Phone Firmware Product Specific
Configuration
Parameter
Phone Firmware Wideband
Release 12.1(1) Headset
or later
Wideband
Headset UI
Control
Phone Firmware Wireless
Release Headset
12.5(1)SR1 or Hookswitch
later, and the Control
latest device
Wideband
package
Headset
Wideband
Headset UI
Control
Description
The headset usually requires about 5 seconds to
upgrade.
The headset usually requires 5 to 15 minutes to
upgrade, and the base LEDs light in sequence to show
the upgrade progress. The user can postpone the
upgrade up to 4 times.
If you are using the Y cable to connect the headset
base to the phone, then you must enable Wireless
Headset Hookswitch Control.
Headsets