Cisco 7800 Series Accessories Manual page 24

Cisco Headset 561 and 562 Buttons and LED
The following table describes the Cisco Headset 561 and 562 Headset buttons.
Table 12: Cisco Headset 561 and 562 Headset Buttons
Number Name
1 Power and Call button
2 Mute button
3 Volume button
4 LED
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
16
Description
Use to power the headset on and off.
Press and hold for 4 seconds to power on and off the headset.
Incoming and active call management depends upon if you have
one call or multiple calls.
One call:
• Press once to answer incoming calls.
• Press once to put an active call on hold. Press again to
retrieve a call from hold.
• Press twice to reject an incoming call.
• Press and hold to end an active call.
Multiple calls:
• Press once to put an active call on hold, and to answer a
second incoming call.
• Press once to put a current call on hold. Press again to resume
a call, or press and hold for 2 seconds to end the current call
and to resume a held call.
• Press and hold to end an active call, and to answer another
incoming call.
• Press twice to stay on a current call, and to reject a second
incoming call.
Toggle the microphone on and off. The Mute
lights when Mute on the headset is enabled.
Adjust the volume on your headset.
Shows the headset status:
• Blinking red—Incoming call.
• Steady red—Active call.
• Blinking white—Firmware upgrade is in progress.
Headsets
on the phone