Table of Contents
Advertisement
Latch Assembly Installation
Before installing the Latch Assembly (Item #1), position the (2) Bearing Block / Sets (Item #3) over the Latch Assy and
make sure that (1) Bearing Block / Set is set between and resting on the washers of the Latch Assy, refer to Figure B.
Position the pre-assembled parts under the Box Frame Assembly (Item #2) aligning the bolt holes of the Bearing
Block / Sets to those of the Box Frame Assy, Refer to Figure A and Figure C.
Secure all parts by using (2) 3/8"-16 x 2" Carriage Bolts (Item #4) and (2) 3/8"-16 Flange Nuts (Item #5) per Bearing
Block / Set. Refer to Figure A.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
Figure B
Figure C
Position under Tilt Base Frame Assy
7
Advertisement
Table of Contents
