Table of Contents
Advertisement
Length Of Hose Adjustment
The hoses in the following steps must be cut to fit your machine. Do not cut the hoses until you have tried to fit them
on your machine. Remember that the hoses need to be long enough to allow for the opening and closing of the
collection system as well as allowing ample clamping surface between each component.
Upper Hose Installation
Slide a Hose Clamp P#(J0060) / P#(J0070) over one end of the 6" or 7"Upper Hose. Secure this end of the Upper
Hose to the Blower Outlet. See Figure below for details. Secure opposite end of the Upper Hose to the Swivel Inlet.
Make sure both ends are securely fastened by tightening the Hose Clamp.
Additional Instructions for Estate Series Units
Lower Hose To Blower Cone Installation
Slide a Hose Clamp P#(J0070) over both ends of the Lower Hose. Secure one end of the Lower Hose to the Blower
Cone and fasten by tightening the Hose Clamp.
Lower Hose To Boot Installation
Take the unattached end of the Lower Hose and secure it to the circular end of the Boot and fasten by tightening the
Hose Clamp.
Tip: Before securing Hose Clamp fully, rotate Lower Hose counter-clockwise (away from yourself) approximately 1" to
aid in retaining Boot to mower deck.
30
Advertisement
Table of Contents
