Latch Assembly Installation - Peco Estate 795001 Operator's Manual

Table of Contents

Advertisement

Latch Assembly Installation

Before installing the Latch Assembly (Item #3), position the (2) Bearing Block / Sets (Item #2) over the Latch Assy and
make sure the Bearing Block / Sets are set between and resting on the washers of the Latch Assy, refer to Figure B.
Position the pre-assembled parts under the Tilt Base Frame Assembly (Item #1) aligning the bolt holes of the Bearing
Block / Sets to those of the Tilt Base Frame Assy, Refer to Figure A and Figure C.
Secure all parts by using (2) 3/8"-16 x 2" Carriage Bolts (Item #4) and (2) 3/8"-16 Flange Nuts (Item #5) per Bearing
Block / Set. Refer to Figure A.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
Figure B
Figure C
Position Between Washers
Position under Tilt Base Frame Assy
7

Advertisement

Table of Contents
loading

Table of Contents