Table of Contents
Advertisement
Ball Clevis Assembly Installation
Estate Series Unit Instructions
Note: The Ball Clevis Assembly (Item #3) will need to be secured onto the rear of your tractor. This may require you to
drill a hole in your bumper to procure the securement. You'll need to first position the Ball Clevis Assembly and mark
where it'll best fit your tractor. An ideal location would be one easily accessible, clear of obstruction and will not affect
the performance of your unit or tractor structurally or functionally.
To install the Ball Clevis Assembly, first, thread (1) 5/8"-11 Hex Nut (Item #2) onto the Adjusting Rod (Item #1) then
place the Adjusting Rod into the Ball Clevis Assembly (Item #3). Place the Ball Clevis (Item #6) at the rear end of the
Ball Clevis Assy. Then, secure the Ball Clevis by using (1) 3/8"-16 x 2-1/4" HHCS (Item #7) and (1) 3/8"-16 Nyloc Nut
(Item #8), refer to the Figure below.
Next, secure the Ball Clevis Assy to the Engine Stay Plate by using (1) Hair Pin Clip (Item #4) and (1) 1/2" Flat
Washer (Item #5).
Finally, secure the Ball Clevis to the rear of your tractor using (1) 3/8"-16 x 1" HHCS (Item #9) and (1) 3/8" Flat
Washer (Item #10).
The Ball Clevis Assy can be positioned along the Engine Stay Plate to better secure the Engine Support Arm.
Note: Some parts and part features have been hidden from view for visual clarity.
Figure A
21
Advertisement
Table of Contents
