Creating A Dl Mimo Signal Using Pathwave N7631Appc Signal Generation - Keysight M9484C Getting Started And Troubleshooting Manual

5G NR Measurements Using the VSA Software
5G Waveform and EVM Analysis Using VSA Software
Creating a DL MIMO Signal Using PathWave N7631APPC Signal
Generation
The VXG must have the N7631APPC Signal Generation for 5G NR license
installed.
This procedure will show you how to configure and analyze a downlink (DL)
multiple input, multiple output (MIMO) signal using PathWave Signal
Generation and the 89600 VSA software. The hardware setup below includes a
2-channel VXG signal generator and a 2+ channel, 33 GHz or higher Infiniium
UXR-Series Oscilloscope.
If you do not have access to a Keysight Infiniium UXR Real-Time Oscilloscope,
TIP
a UXR recording waveform file has been included in the Example waveform
file folder:
D:\Users\Instrument\Documents\Keysight\PathWave
\SignalGenerator\Examples
You will need to copy the 5GNR_UXR_Recording_28GHz.csv file to the
X-Series Signal Analyzer or the PC running the VSA application. Steps have
been included below to successfully run the recording.
Equipment Setup for the M9484C
— M9484B CH1 front panel RF Out to UXR front panel CH1
— M9344B CH2 front panel RF Out to UXR front panel CH3
— M9484C front panel Channel 1 Event 2 to UXR rear panel Aux Trig In
— M9484C rear panel 10 MHz Out to UXR rear panel 10 MHz Ref In.
M9484C Measurement Guide 221