Table of Contents
Advertisement
Basic Measurements
Making Measurements
Making Measurements
Creating a Continuous Waveform (CW)
This procedure will demonstrate the amplitude and frequency accuracy of the
VXG at RF and µW frequencies.
Ensure the equipment and triggers are properly configured. Refer to
"Equipment Setup" on page 9
Signal Analyzer" on page 11
Using the graphical user interface
On the VXG:
1. Select Preset > Preset to set the instrument to a known state.
2. In the Output area, set Frequency to 1 GHz and Power to 0 dBm.
3. Set RF Out to On by selecting the numbered channel indicator switch.
4. For multi-channel instruments only: In the top right corner of the display,
In order to turn on RF for any channel, both the RF Out for the specific
channel (for example, Channel 1 or Channel 2), and RF Out All must be
turned on.
On the X-Series Signal Analyzer:
1. Select Mode Preset to set Spectrum Analyzer mode to a known state.
12
These values are coupled to CW Frequency and Total Power (RMS) in the
corresponding RF Output Block.
This enables the RF Out for the indicated channels, in this case Channel 1
if using a multi-channel VXG.
set RF Out (All) to On by selecting the switch.
"Setting Up Triggers on the X-Series
and
.
M9484C Measurement Guide
Advertisement
Table of Contents
