Canon MK5000 Basic Operation Manual page 25

4
Insert the tube (or plate)�
⿟ Insert the tip of the tube (or plate) into the
media feed port in the direction shown in
the figure, and push it in until it hits transport
roller 2.
For tubes (round):
Transport roller 2
For flat tubes and plates:
Transport roller 2
NOTE
• If it is difficult to pass the tube (or plate) through
the attachment, set the tube (or plate) in place
while pressing the tube retainer lever with your
finger.
IMPORTANT
• If the tip of the tube
(or plate) is inserted as
shown in the figure, the
tube (or plate) may get
stuck during printing, the
print may be chipped, or
the cut position may be
off.
• If the tip of the tube (or plate) is bent due to
winding, etc., fix it so that it is straight, or cut off the
bent portion before placing it in the printer.
• To prevent the print media from running out
during printing, or to prevent the shortened print
media from getting stuck inside the printer, use a
tube (or plate) of sufficient length.
• If the tube (or plate) is not set correctly, this device
may print onto the transport roller.
5
Close the cover�
Basic Operations
21