4 Mounting SMV800 SmartLine Temperature
4.1 Summary
Transmitter models can be attached to a 2-inch (50 millimeter) vertical or horizontal pipe using
Honeywell's optional angle or flat mounting bracket; alternately you can use your own
bracket.
Figure 4
shows typical bracket-mounted transmitter installations.
4.2 Mounting Dimensions
Refer to Honeywell drawing number 50049930 (SMV800), for detailed dimensions. Abbreviated
overall dimensions are also shown on the Specification Sheets for the transmitter models. This section
assumes that the mounting dimensions have already been taken into account and the mounting area
can accommodate the Transmitter.
4.3 Bracket Mounting Procedure
Procedure for mounting the Transmitter using the optional bracket:
1. Refer to
Figure
5. Position the bracket on a 2-inch (50.8 mm) horizontal or vertical pipe and
install a "U" bolt around the pipe and through the holes in the bracket. Secure the bracket with the
nuts and lock washers provided.
Figure 5 – Angle Mounting Bracket Secured to a Horizontal or Vertical Pipe
Page 14
Transmitters
Figure 4 – Typical Bracket Mounted Installations
Nuts and
Lockwashers
Mounting
Bracket
Horizontal Pipe
U-Bolt
SMV800 Transmitter User's Manual
Nuts and
Lockwashers
U-Bolt
Mounting
Bracket
Vertical Pipe
Revision 10