3.4 Mounting ST 700 SmartLine Pressure Transmitters
3.4.1 Summary
Transmitter models, except flush mounts and those with integral flanges, can be attached to a two-
inch (50 millimeter) vertical or horizontal pipe using Honeywell's optional angle or flat mounting
bracket; alternately you can use your own bracket. Flush-mount models are attached directly to a
process pipe or tank by a one-inch weld nipple. Models with integral flanges are supported by the
flange connection.
Figure 4 shows typical bracket-mounted and flange-mounted transmitter installations.
Figure 4 – Typical Bracket Mounted and Flange Mounted Installations
3.4.2 Mounting Dimensions
Refer to Honeywell drawing number 50049930 (Dual Head), 50049931 (In-Line), 50049932 (Flange
Mount) 50049933 (Extended Flange), and 50049934 (Remote Seal) for detailed dimensions.
Abbreviated overall dimensions are also shown on the Specification Sheets for the transmitter
models. This section assumes that the mounting dimensions have already been taken into account and
the mounting area can accommodate the Transmitter.
Page 72
ST 700 SmartLine Pressure Transmitters User's Manual
Revision 1.0