Recycling And Disposal Of Product - Honeywell SMV800 SmartLine User Manual

19. Tighten Set Screw.
20. Loosen Set Screw by half turn.
21. Rotate Electronics Housing to the desired position (caution, do not rotate more than 180° to
prevent damage to Sensor Cable).
22. Carefully align and connect Sensor Cable Connector to connector "J4" at the bottom of
Communication Module. When installing Communication Module in the next step, be careful not
to pinch Sensor Cable.
23. Carefully, insert the Communication Module into the Electronics Housing. Ensure that Sensor
Cable is not pinched.
24. Tighten the two screws retaining Communication Module.
25. If applicable, reinstall Display Module by:
a. Orient Display Module to desired view angle by aligning one of the four sockets on Display
Module separated by 90° angle with Communication Module.
b. Insert Interface Connector to the Display Module socket, then snap to Communication
Module socket carefully till the two tabs properly latched.
26. Lubricate the end-cap O-ring with Parker Super O-ring silicone lubricant or equivalent, then
screw End Cap back to Electronics Housing
27. Restore configuration data.
28. Recalibrate Transmitter per
29. Connect the bracket to Process Heads.
30. Return Transmitter to service, then turn on power
31. Verify Transmitter operates properly.

10.6 Recycling and Disposal of product

Please consider recycling the product and packaging materials. The product should be disposed
of in accordance with local and national regulations.
Page 70
Section 11 Calibration.
SMV800 Transmitter User's Manual
Revision 10