Table 21 - Flow Setup Menus - Honeywell SMV800 SmartLine User Manual

Fl Damping sec
Mass Fl Units
Vol Fl Units
Dev Flow Unit
***
Barom
Pressure
Flow
Parameters
K-User Factor
Algorithm Type
Compens
Mode
Fluid State
Pri Elem Type
Pipe Diameter
Flow Cust Unit
***
Page 52
Table 21 – Flow Setup Menus
Enter a value for damping for the flow
output. Entries may be any value from 0.00
to 100.00 seconds.
Displays the engineering units currently
selected in the Display Common Setup for
displaying values of mass flow URL, LRV,
URV, and flow cutoff limits in this menu only.
Displays the engineering units currently
selected in the Display Common Setup for
displaying values of volume flow URL, LRV,
URV, and flow cutoff limits in this menu only
Displays the engineering units currently
selected for Flow.
Enter the value in psia that represents the
local barometric pressure
Displays the value entered for the K-User
factor during configuration of the flow equation.
Displays the flow algorithm type (SMV3000
legacy or SMV800 category) selected during
configuration of the flow equation.
Displays the flow compensation mode
(dynamic or standard (for SMV3000 legacy
equations only)) selected during
configuration of the flow equation.
Displays the fluid state (gas, liquid, steam,
etc.) selected during configuration of the flow
equation.
Displays the primary flow element type
(orifice, nozzle, etc.) selected during
configuration of the flow equation.
Displays the entered/read value of the width
of the pipe used in the process
Custom Unit Tag when user selects a
custom unit.
A custom unit label to be displayed on flow
readings.
User can Enter the desired custom unit label
to be displayed for the flow Reading. Up to
Eight characters including letters, numbers,
and symbols can be entered in the custom
unit field.
SMV800 Transmitter User's Manual
Press  to enter
menu selection
and  to select
number.
 to enter and shift
to next digit
Read only
Read only
Press  to enter
menu selection
and  to select
number.
Press  to enter
menu selection
and  to select
number.
 to enter and shift
to next digit
Read only
Read only
Read only
Read only
Read only
Press  to enter
menu selection
and  to select
number.
 to enter and shift
to next digit
Revision 10