Table 14 - Diagnostics Menu - Honeywell SMV800 SmartLine User Manual

All Diagnostics menu items are Read Only (Italics).
Key:
Parameters in Italics are read-only.
* HART only
** HART and DE
*** HART and Modbus
<Return> Return to the Level 1 menu
Active Diags
Meter Body
Meter Body
Comm
Temp Sensor
Board
Critical
Temp Input
Temp Sensor
Comm
Comm Module
Comm Vcc Fault
Active Diags
Analog Out Mode
**
Non-Critical
Write Protected
(Modbus only)
Page 36
Table 14 – Diagnostics Menu
# #
OK
FAULT
OK
FAULT
OK
FAULT
OK
FAULT
OK
FAULT
OK
FAULT
OK
FAULT
# #
Normal
FIXED OUTPUT
No/Yes
SMV800 Transmitter User's Manual
Lists the number of active
diagnostics
FAULT: There is a problem with
the Meter body
FAULT: There is a problem with
the Meter body Comm
FAULT: There is a problem with
the temperature module
FAULT: The temperature input is
open, and the loop control is
process temperature
FAULT: There is a problem with
communication between the comm
and temp sensor.
FAULT: There is a problem with
the Comm Module (HART, DE)
FAULT: There is a problem with
the power supplied to the comm.
Shows the number of Non-Critical
Diagnostics that are currently
active
Normal indicates that the Loop
Output reflects the current value
of the PV.
FIXED OUTPUT indicates that the
Loop Output of the transmitter is
at a fixed value and not
responding to process input. This
may be due to Loop Current mode
(or Analog Output mode) being
disabled, or it may be due to a
DAC Trim or Loop Test operation
that is currently in progress.
Yes indicates Modbus device is in
write protected mode and device
configuration cannot be changed.
No indicates that device is not in
write protected mode.
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read only
Read
Only
Revision 10