Brother 882-W73 Operation Manual page 148

VARIOUS EMBROIDERING FUNCTIONS
i
Use two layers of adhesive water soluble stabilizer
material with their sticky sides together, and then hoop
them in the embroidery frame.
Note
• If water soluble stabilizer is used, it is not
necessary to remove the stabilizer material after
sewing the appliqué outline. To reduce shrinkage
of the pattern, we recommend using water soluble
stabilizer.
• Put together two layers of water soluble stabilizer,
otherwise the stabilizer material may tear during
embroidering.
j
Thread the machine with the thread for the outline,
and then sew the placement line for the appliqué
position (APPLIQUE POSITION).
1 Pattern placement line
k
Lightly apply glue or spray adhesive, and paste the
appliqué piece so that it aligns with the placement line.
Note
• Before pasting the appliqué piece down, make sure
the appliqué piece is positioned correctly within the
placement line.
146
a
l
With the machine threaded using the thread for the
j
outline from step , embroider the outline
(APPLIQUE).
a
Memo
• The outline is sewn using satin stitching.
• Since glue may become attached to the presser
foot, needle or needle plate, clean off any glue after
finishing embroidering the appliqué pattern.
m
After embroidering is finished, remove the stabilizer
material from the embroidery frame.
n
Use scissors to cut the excess water soluble stabilizer
from outside the appliqué outline.
o
Soak the appliqué piece in water to dissolve the water
soluble stabilizer.
p
Dry the appliqué piece, and then iron it if necessary.
Note
• Do not apply a strong force when ironing,
otherwise the stitching may be damaged.
1 Outline of appliqué
piece