List Of Symptoms - Brother 882-W73 Operation Manual

c
Push the bobbin winder switch to the right, and then
remove the bobbin from the shaft and cut the thread
leading to the bobbin in order to be able to completely
remove the bobbin from shaft.
d
Hold the thread end with your left hand, and wind off
the thread clockwise from under the bobbin winder
seat with your right hand as shown below.

List of Symptoms

Check the following possible problems before requesting
service. If the reference page is "*", contact your
authorized Brother dealer or the nearest Brother
authorized service center.
 Getting Ready
Symptom, Cause/solution
Cannot thread the needle.
Needle is not in the correct position.
• Press (Needle position button) to raise
the needle.
Needle is installed incorrectly.
Needle is turned, bent or the point is dull.
Upper threading is incorrect.
The needle threader hook is bent and does not
pass through the eye of the needle.
The needle threader lever cannot be moved or
returned to its original position.
A size 65/9 needle is being used.
• The needle is incompatible with the needle
threader. Manually pass the thread through the
eye of the needle.
Cannot lower the presser foot with the presser foot
lever.
Presser foot was raised using
lifter button).
• Press (Presser foot lifter button) to lower
the presser foot.
Bobbin thread does not wind neatly on the bobbin.
The thread is not passed through the bobbin
winding thread guide correctly.
Bobbin spins slowly.
The thread that was pulled out was not wound
onto the bobbin correctly.
The empty bobbin was not set on the pin
properly.
While winding the bobbin, the bobbin thread was
wound below the bobbin winder seat.
You have not wound the bobbin thread properly
when you initially wound thread on the bobbin.
Ensure that the bobbin thread was properly set in
the guides.
TROUBLESHOOTING
Reference
10
42
42
36
*
*
38
10
(Presser foot
31
32
32
30
30
187
7