Table of Contents
Advertisement
UTILITY STITCHES
e
Unfold the edge of fabric, and position the fabric with
the wrong side facing up.
a
d
a
a
a
a f
a
<Seen from the side>
f
Select a stitch.
g
Attach blind stitch foot "R".
h
Remove the flat bed attachment to use the free arm.
i
Slide the item that you wish to sew onto the free arm,
make sure that the fabric feeds correctly.
a
j
Position the fabric with the edge of the folded hem
against the guide of the presser foot, and then lower
the presser foot lever.
k
Adjust the stitch width until the needle slightly catches
the fold of the hem. (page 57)
80
1 Wrong side of fabric
2 Right side of fabric
3 Edge of fabric
4 Desired edge of hem
5 Basting point
6 Basting
c
<Thick fabric>
e
b
<Normal fabric>
1 Free arm
1 Wrong side of
fabric
2 Fold of hem
3 Guide
1 Needle drop point
When you change the needle drop point, raise the
needle, and then use
needle drop point. (The stitch width setting is in
neither millimeters nor inches.)
a
Memo
• Blind hem stitches cannot be sewn if the left needle
drop point does not catch the fold. If the needle
catches too much of the fold, the fabric cannot be
unfolded and the seam appearing on the right side
of the fabric will be very large, leaving an
unattractive finish.
l
Sew with the fold of the hem against the presser foot
guide.
m
Press the "Start/Stop" button to stop sewing when you
are finished, and raise the presser foot and needle to
pull the fabric under the presser foot towards the left
of the machine.
IMPORTANT
• Be sure to pull the fabric towards the back of
the machine after sewing. If you pull the fabric
toward side or forward, the presser foot may
be damaged.
n
Remove the basting stitching and turn the fabric with
the right side facing out.
1
and
to decide the
1 Thick fabric
2 Normal fabric
1 Wrong side of
fabric
2 Right side of
2
fabric
Advertisement
Table of Contents
