Table of Contents
Advertisement
WINDING/INSTALLING THE BOBBIN
f
Pass the thread around the pretension disk making sure
that the thread is under the pretension disk.
1 Pretension disk
Make sure that the thread passes under the
pretension disk.
2 Pretension disk
3 Pull it in as far as possible.
Check to make sure thread is securely set between
pretension disks.
g
Wind the thread clockwise around the bobbin 5 or 6
times, pass the thread through the guide slit in the
bobbin winder seat, and then pull the thread to cut it.
1 Guide slit in bobbin winder seat
(with built-in cutter)
Note
• Be sure to wind the thread clockwise around the
bobbin, otherwise the thread may become
wrapped around the bobbin winder shaft.
CAUTION
• Be sure to cut the thread as described. If the
bobbin is wound without cutting the thread
using the cutter built into the guide slit in the
bobbin winder seat, the thread may become
tangled in the bobbin or the needle may break
and cause injury when the bobbin thread starts
to run out.
32
a
c
a
h
Set the bobbin winding switch to the left, until it clicks
into place.
a
1 Bobbin winding switch
The bobbin winding window appears.
i
Touch
.
1
1 Touch to decrease the winding speed.
2 Touch to increase the winding speed.
Bobbin winding starts.
while the bobbin is winding. The bobbin stops
rotating when bobbin winding is completed. The
bobbin winding switch will automatically return to
its original position.
Memo
• Touch
to minimize the bobbin winding
window. Then, you can perform other operations,
such as selecting a stitch or adjusting the thread
tension, while the bobbin is being wound.
• Touch
(in top right of the LCD screen) to
display the bobbin winding window again.
• The sound of winding the bobbin with stiff thread,
such as nylon thread for quilting, may be different
from the one produced when winding normal
thread; however, this is not a sign of a malfunction.
IMPORTANT
• When winding transparent nylon thread on the
bobbin, stop bobbin winding when the bobbin
is 1/2 to 2/3 full. If the bobbin was fully
wound with transparent nylon thread, it may
not be wound neatly, or sewing performance
may suffer. In addition, extreme pressure may
be applied to the bobbin, it may not be
possible to remove the bobbin from the bobbin
winder shaft, or the bobbin may break.
2
changes to
Advertisement
Table of Contents
