Table of Contents
Advertisement
FatTwin F617H6-FT+/FTPT+ USER'S MANUAL
Terminal Type
This feature allows the user to select the target terminal emulation type for
Console Redirection. Select VT100 to use the ASCII character set. Select
VT100+ to add color and function key support. Select ANSI to use the extended
ASCII character set. Select VT-UTF8 to use UTF8 encoding to map Unicode
characters into one or more bytes. The options are VT100, VT100+, and VT-
UTF8, and ANSI.
Bits Per Second
This item sets the transmission speed for a serial port used in Console
Redirection. Make sure that the same speed is used in the host computer and
the client computer. A lower transmission speed may be required for long and
busy lines. The options are 9600, 19200, 57600, and 115200 (bits per second).
Flow Control
This feature allows the user to set the fl ow control for Console Redirection to
prevent data loss caused by buffer overfl ow. Send a "Stop" signal to stop sending
data when the receiving buffer is full. Send a "Start" signal to start sending data
when the receiving buffer is empty. The options are None, Hardware RTS/CTS,
and Software Xon/Xoff.
Data Bits, Parity, Stop Bits
The setting for each of these features is displayed.
ACPI Settings
Use this feature to confi gure Advanced Confi guration and Power Interface (ACPI)
power management settings for your system.
ACPI Sleep State
Use this feature to select the ACPI State when the system is in sleep mode. Select
S1 (CPU Stop Clock) to erase all CPU caches and stop executing instructions.
Power to the CPU(s) and RAM is maintained, but RAM is refreshed. Select
Suspend Disabled to use power-reduced mode. Power will only be supplied to
limited components (such as RAMs) to maintain the most critical functions of the
system. The options are Suspend Disabled and S1 (CPU Stop Clock).
NUMA (NON-Uniform Memory Access)
This feature enables the Non-Uniform Memory Access ACPI support. The options
are Enabled and Disabled.
7-22
Advertisement
Table of Contents
