Push Handles - Meyra Eurochair2 2.750 Operating Manual

PUSH HANDLES

The height adjustable push handles are
about 20 cm continuously height adjustable
and secured against being pulled out [1].
Push handles with clamping device
☞ In doing so, hold onto the push handle
that is to be adjusted with one hand.
☞ After each adjustment the clamping
lever is to be tightened sufficiently, so
that the push handle cannot be turned
anymore.
Height adjustment:
Loosen the clamping screw with the clamp-
ing levers (2) so far that the respective push
handle can be adjusted into the desired po-
sition.
Angle adjustment:
In order to turn the push handles, loosen
the clamping screw through the clamping
lever (2) and turn into the desired position.
Extracting/inserting:
1. Press down the respective spring but-
ton (3) in order to extract or insert the
push handles.
2. Afterwards retighten the clamping
screw with the clamping levers (2).
Special features of the clamping lever
The clamping lever (2) can be turned into
an operation position that is comfortable
for you.
For this pull the clamping lever (2) outward
(direction of the arrow), until the teething is
released.
After turning the clamping lever (2) let the
teething snap back into place.
30
1
2
3