Back shell
(only on model 2.750, 2.850)
The back support shell [1] needs to be re-
moved before folding the wheelchair.
Removing the back support shell
1.
Operate parking brakes.
☞ Therefore observe chapter Brake on
page 12.
2. Unscrew the knurled screws (2) of the
back support shell.
3.
Jerk the back support shell forward out
of the back support tubes and remove
toward the top.
4. Screw the knurled screws back into the
thread sockets of the tube clamps.
☞ This way the knurled screws will not
get lost.
Assembly of the back support shell
1.
Screw the knurled screws out of the
threaded sleeve of the tube clamps.
2. Place the back support shell onto the
bolts (3).
3.
Press the tube clamps onto the back
support tubes.
4. Reattach the knurled screws (2).
28
1
2
3