Contec BX-M2510 Series Reference Manual page 82

Item
HWM
COM Address Check
COM IRQ Check
UARTx
SSD Life
LAN EEPROM Check
CONTEC MAC
Unique MAC
Good CS
x MAC
x CS (0x00 - 0x3F)
Temprature
Voltage
Time
GPIO Info
GPIO(0 - 5)
ROMCLR
The overall Pass or Fail
— —
BIOS Setup
BX-M2510 Series Reference Manual
Option
ACTIVE
INACTV
PASS
FAIL
PASS
FAIL
xxx
x/x/x
Display only
PASS
FAIL
PASS
FAIL
PASS
FAIL
PASS
FAIL
xxxxxxxxxxxx
xxxx
MIN
NOW
MAX
MIN
NOW
MAX
Now
Elapsed
111111
OFF
ON
PASS
FAIL
- 82 -
Description
[FAIL] is displayed if even one expected
device cannot be confirmed or resources
are inappropriate.
Checks whether the expected HWM devices
are present. [ACTIVE] is displayed if the
device is confirmed as present.
[INACTV] is displayed if the device cannot
be confirmed.
Check whether the address for COM
resource is correctly set.
Check whether the IRQ for COM resource is
correctly set.
Display the address and the IRQ for each
COM.
Displays the SATA drive service life
information.
Information will be displayed correctly only
for the SATA drive equipped as standard.
Check whether the LAN EEPROM data is
correct.
Checking will not be possible if no LAN
device is found.
Check whether the MAC data from CONTEC
has been written.
Check whether the MAC data is unique in
the actual device.
Check whether the checksum is correct.
Displays the MAC data for each port.
Displays the checksum for each port.
Displays the minimum, maximum, and
current CPU temperature and system
temperature values during self-diagnosis.
Displays the minimum, maximum, and
current voltage values during self-
diagnosis.
Displays the current time and the elapsed
self-diagnosis run time.
Displays the GPIO information.
Displays the signal level of GPIO pins 0 to 5.
Displays the ROM clear switch status.
[PASS] is displayed if all PCI Device Activity,
LPC Device Activity and LAN EEPROM
Check items pass. [FAIL] is displayed if even
one item fails.