Contec BX-M2510 Series Reference Manual page 62

 Super IO Configuration
Use this menu to configure the operation settings for Super IO.
Super IO Configuration
Item
Serial Port 1 Configuration
Serial Port 2 Configuration
Serial Port 3 Configuration
Serial Port 4 Configuration
Digital I/O Configuration
Serial Port 1 Configuration
Item
Serial Port
Device Settings
Mode select
RS-422/485 Terminator Control
RS485 Auto Flow Control
—
BIOS Setup
BX-M2510 Series Reference Manual
Options
Refer to "Serial Port 1 Configuration"
Refer to "Serial Port 2 Configuration"
Refer to "Serial Port 3 Configuration"
Refer to "Serial Port 4 Configuration"
Refer to "Digital I/O Configuration"
Options
Disabled / Enabled
IO=3F8h; IRQ=4;
RS-232
RS-485 Half Duplex
RS-485/422 Full Duplex
Disabled / Enabled
Disabled / Enabled
- 62 -
—
Configure the serial A settings.
Configure the serial B settings.
Configure the serial C settings.
Configure the serial D settings.
Configure the DIO settings.
Description
Configure the operation settings for serial
port 1.
Display the device settings.
Configure the communication mode for serial
port 1.
Configure to enable or disable RS-422/485
terminators. Only available when "RS-422 or
RS-485" is selected for Mode Select.
RS-485 is communicating on half duplex, and
the same pin is shared for transmission and
reception. Therefore, controlling by RTS
Description