Update The Firmware - Sungrow AC011E-01 User Manual

5 Commissioning via Web UI
• The charger is online.
• The charger is not in use.
• The charger has connected to a power-controlling device. See
cation Connection".
step 1 Log in to the web UI
step 2 On the Home page, select Charger Settings.
step 3 On the Charger Settings page, select Load Balancing.
step 4 Select the device you have for power-controlling, and click Next.
step 5 Based on the devices you select, you can modify the following:
Option
CT Ratio
Maximum Available Current
step 6 Click Confirm to apply the changes.
- - End

5.3.3 Update the Firmware

You can update the firmware of the charger on-site via the AP mode.
• Your phone and the charger have connection to the Internet.
• The charger is available.
• There is a new version of the firmware.
It is recommended to update the firmware via iEnergyCharge. See
the Firmware
It is recommended to use Safari or Chrome browsers only because other brows-
ers might cause an unexpected error when upgrading.
Contact customer service for available firmware packages if needed.
step 1 Log in to the Web UI.
step 2 On the Home page, select Charger Settings.
step 3 On the Charger Settings page, select Upgrade Firmware.
step 4 Click Browse and select the firmware package.
Currently, only .enfs format is supported.
28
Remotely".
"2.4.3 RS485 Communi-
Description
The default value is set to 3:100.
Range: 10-100 A
User Manual
"6.3.2 Update