Table of Contents
Advertisement
6
Maintenance, care and disposal
Risk of injury from electric shock!
Cleaning machines that are not disconnected from the mains can lead to serious
injuries!
•
Disconnect the machine completely from the mains.
•
Remove the mains plug!
•
Wait for 4 minutes until the capacitors have discharged!
6.1
General
When used in the specified environmental conditions and under normal operating conditions, this
machine is largely maintenance-free and requires a minimum of care.
There are some points, which should be observed, to guarantee fault-free operation of your welding
machine. Among these are regular cleaning and checking as described below, depending on the pollution
level of the environment and the length of time the unit is in use.
6.2
Maintenance work, intervals
6.2.1
Daily maintenance tasks
6.2.1.1
Visual inspection
•
Mains supply lead and its strain relief
•
Gas tubes and their switching equipment (solenoid valve)
•
Other, general condition
6.2.1.2
Functional test
•
Check correct mounting of the wire spool.
•
Welding current cables (check that they are fitted correctly and secured)
•
Gas cylinder securing elements
•
Operating, message, safety and adjustment devices (Functional test)
6.2.2
Monthly maintenance tasks
6.2.2.1
Visual inspection
•
Casing damage (front, rear and side walls)
•
Wheels and their securing elements
•
Transport elements (strap, lifting lugs, handle)
•
Check coolant tubes and their connections for impurities
6.2.2.2
Functional test
•
Selector switches, command devices, emergency stop devices, voltage reducing devices, message
and control lamps
•
Check that the wire guide elements (inlet nipple, wire guide tube) are fitted securely.
099-005148-EW501
01.03.2012
Maintenance, care and disposal
DANGER
General
43
Advertisement
Table of Contents
Need help?
Do you have a question about the Taurus 301 Basic FKG and is the answer not in the manual?