Table of Contents
Advertisement
15 Commissioning
15.1 Commissioning on the device
1. Ensure that the "ON-Site" DIP switch 8 is not in the "ON"
position (see "Buttons for on-site control", page 6).
2. Press and hold down the "INIT/CLOSE" button 10 for at
least 8 s.
ð Initialization of the actuator begins.
3. Green and orange LEDs flash alternately.
ð Initialization is completed.
ð Commissioning is completed.
15.2 Commissioning via the eSy-Web web interface
● See separate eSy-Web operating instructions.
15.3 Commissioning via digital input
ü The function of input 3 is set to init.
1. Apply 24 V DC signal briefly (max. 2 s) to connection X3
pin 6 (reference GND connection X3 pin 4).
ð Initialization of the actuator begins.
2. Green and orange LEDs flash alternately.
ð Initialization is completed.
ð Commissioning is completed.
16 Operation
16.1 Operation on the device
16.1.1 Moving the valve to the open position
1. Move the "ON-Site" DIP switch 8 to the "ON" position (see
"Buttons for on-site control", page 6).
ð Control on the device is activated.
2. Press the "OPEN" button 9.
ð The valve moves slowly to the open position.
3. Also press the "INIT/CLOSE" button 10.
ð The valve moves quickly to the open position.
ð If the valve is fully opened, the high visibility LEDs are
lit in green.
4. Move the "ON-Site" DIP switch 8 to the "OFF" position.
ð Control on the device is deactivated.
ð The valve is in the open position.
16.1.2 Moving the valve to the closed position
1. Move the "ON-Site" DIP switch 8 to the "ON" position.
ð Control on the device is activated.
2. Press the "INIT/CLOSE" button 10.
ð The valve moves slowly to the closed position.
3. Also press the "OPEN" button 9.
ð The valve moves quickly to the closed position.
www.gemu-group.com
ð If the valve is fully closed, the high visibility LEDs are lit
in orange.
4. Move the "ON-Site" DIP switch 8 to the "OFF" position.
ð Control on the device is deactivated.
ð The valve is in the closed position.
16.2 Operation via the web server
See separate "eSy-Web" operating instructions.
16.3 Manual override
Rotating cover!
▶ Risk of crushing.
●
1. Disconnect the power supply.
2. Turn housing cover 3 clockwise.
3. Remove housing cover 3.
3
4. Place the actuator of housing cover 12 in the starting
point for manual override.
3
Item
3
12
27 / 36
WARNING
Disconnect the power supply before
using the manual override.
Name
Housing cover
Housing cover actuator
GEMÜ 343 eSyDrive
16 Operation
12
Advertisement
Table of Contents
