Oil Shutdown; Oil Tmr/Cntr - Vulcan-Hart GRC 35 Installation & Operation Manual

OIL SHUTDOWN

The oil service has two modes:
Shutdown = ON - Counter with Shutoff
The operator sets the number of product cook cycles
before oil service action is taken by the controller.
After that number of cook cycles has elapsed, the
heat will be shut off, a SERVICE OIL message will be
flashed on the display, and the keypad will be locked
out. Turning the fryer off, then on, will clear the
condition and restore the count number set by COUNT
= XXX in the following section.
Shutdown = Off - Timer without Shutoff
The controller keeps track of the number of hours
since OIL TM = XXX HR was set by the operator.
When the time has elapsed, a small oil indicator light
will turn on. Service of the fryer is not interrupted. The
oil indicator remains lit until a time is re-entered for
OIL TM = XXX HR in the following section. Turning
the fryer off, then on, will clear the indicator.
DISPLAY
READY
-FUNCTIONS-
EDIT PRODUCT
SEL SETBACK
CALIBRATE
BOIL OUT
RECOVERY
SELECT MELT
MANUAL SETUP
OIL SHUTDOWN
COUNT ON
COUNT OFF
OIL SHUTDOWN
-FUNCTIONS-
READY
INSTRUCTION
Press 2 & 3 simultaneously.
Press .
Press .
Press .
Press .
Press .
Press .
Press .
Press .
Press ENTER.
Press or to toggle
.
When OK, press EXIT.
Press EXIT.
Press EXIT.

OIL TMR/CNTR

The controller will alert the operator when the oil
needs to be changed. OIL TM = XXX sets the
number of hours before the alert will be given.
DISPLAY
READY
-FUNCTIONS-
EDIT PRODUCT
SEL SETBACK
CALIBRATE
BOIL OUT
RECOVERY
SELECT MELT
MANUAL SETUP
OIL SHUTDOWN
OIL TMR/CNTR
OIL TM = XXX HR /
COUNT = XXX
OIL TMR/CNTR
-FUNCTIONS-
READY
If oil shutdown is OFF: The controller will alert the
operator when the oil needs to be changed. OIL TM
= XXX sets the number of hours before the alert will
be given.
If oil shutdown is ON: The controller will shut off the
heat, lock out the keypad, and signal to service the oil.
The fryer must be turned off to clear this condition.
COUNT = XXX sets the number of cook cycles before
shutoff. Turning the fryer off, then on, automatically
restores "COUNT = XXX" to the number originally set
by the operator.
– 22 –
INSTRUCTION
Press 2 & 3 simultaneously.
Press .
Press .
Press .
Press .
Press .
Press .
Press .
Press .
Press
.
Press ENTER.
Use or to reset the
timer or counter. When set
time is OK, press EXIT.
Press EXIT.
Press EXIT.