Barco R9840700 Quick Reference page 2

Shooting a Document
1
Perform connections.
Connect a monitor or projector to the RGB connector on
the rear of this unit. For details, refer to page 13 of the
User's Manual.
2
Turn on the unit.
Press the POWER switch down to the  side.
POWER
3
Turn on the monitor or projector.
For details, refer to the operation manual for the
connected equipment.
4
Perform the input selection on
the monitor or projector.
Set it so that the picture from this unit is displayed.
5
Turn on the lamps.
Press the LIGHTS button.
Pressing the button switches the overhead lighting to
the lower built-in light.
L For opaque material
Use the overhead lighting.
L For transparent material
Use the built-in light under the document stage.
6
Place the material on the
document stage.
Top
approx.
Bottom
7
Adjust the image size.
Press the ZOOM W or T button. When you hold the
button pressed, the image size changes continuously.
ZOOM W button
Press to widen the area
to be captured.
297 mm × 420
mm width wide
210 mm × 297
mm upright
ZOOM
W T
ZOOM T button
Press to enlarge the
image (max. 6 times).