Lshooting A Document - Barco R9840700 Quick Reference

Shooting a Document
Shooting a Document
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
This unit accepts both opaque (to be shot with overhead lighting) and transparent materials (such as films, to be shot
with base lighting).
Press the POWER switch to
1
turn the power on.
The POWER indicator lights.
Press the POWER switch down to the side.
POWER
Note
[ When turning the power off then on
again, leave it off for at least 10 sec-
onds before turning it back on.
Turn on the connected equip-
2
ment (monitor, etc.).
For details, refer to the operation manual for the
connected equipment.
Perform the input selection
3
on the connected equipment
(monitor, etc.) so that the pic-
ture from this Imager is dis-
played.
For details, refer to the operation manual for the
connected equipment.
18
**BARCO 018-037(E) 18-19
Press the LIGHTS button.
4
Each time you press the button, the illumination
changes as follows:
You can set the lights to turn on automatically when
the power is turned on (after a warmup period of
approx. 8 seconds). ( p.24)
Overhead lighting on
(the UPPER indicator lights.)
Base lighting on
(the LOWER indicator lights.)
Both off, and so on.
LIGHTS
button
LIGHTS
UPPER LOWER
For opaque material
Use the overhead lighting.
For transparent material
Use the built-in light under the document stage.
The same operation can be performed
using the menu. ( p.24)
Shooting a Document
Place the material on the
5
document stage.
297 mm ×
420 mm
widthwise
210 mm ×
297 mm
upright
Document
stage
CARD MENU MENU
Note
[ The maximum size for opaque mate-
rial is 297 mm in height and approx.
420 mm in width. Transparent mate-
rial must fit within the area of the
document stage.
(Only when using an opaque
6
document)
Adjust the direction of the
lighting.
Finely adjust it while observing the room lighting
conditions so that the image will be clearly dis-
played.
2000.7.18, 8:19 PM
Adjust the image size by
7
pressing the ZOOM W or T
button.
When you hold the ZOOM W or T button pressed,
the image size changes continuously.
ZOOM
W T
ZOOM W button ZOOM T button
Press to widen the Press to enlarge the
area to be captured. image (max. 6 times).
Note
[ When you press the E-ZOOM button,
the electronic zoom function is acti-
vated, and the E-ZOOM indicator
lights. The image size becomes two
or four times that adjusted with the
ZOOM W/T buttons.
Continue
19