Sage Barista Touch Impress User Manual page 13

• The machine will calculate how much to reduce
the auto grind time and apply this for the next
cycle.
OVER DOSE (TRIMMING THE DOSE)
Precision dose trimming tool
The Razor™ precision dose trimming tool
allows you to trim the puck to the right level
for a consistent extraction.
Insert the Razor™ into the coffee basket until
the shoulders of the tool rest on the rim of the
filter basket. The blade of the dosing tool should
penetrate the surface of the tamped coffee.
Rotate the Razor™ dosing tool back and forth
while holding the portafilter on an angle over
the knock box to trim off excess coffee.
Inserting the Portafilter
Place the portafilter underneath the group head
so that the handle is aligned with the INSERT
position. Insert the portafilter into the group
head and rotate the handle towards the centre
until resistance is felt.
ESPRESSO EXTRACTION
• Select a display of brew options on the screen.
• Select the café size options from:
Single (approx.30ml), Double (approx.60ml) or
Double+ (approx.90ml).
• Select Custom and slide and drag the dot to
increase or decrease the coffee volume.
• Tap the coffee cup image on the screen to start
extraction.
• The duration times are preset but can be
customised.
MANUAL OVERRIDE
Press and hold the coffee image (approx
2 seconds) to enter manual extraction mode.
Touch the coffee image to start the extraction,
touch the coffee image again to stop the
extraction.
NOTE
• The amount of espresso extracted in the cup
will vary depending on your grind size and grind
amount settings.
• Touching the coffee image during a preset shot
volume will immediately stop the extraction.
• For optimal flavour when using a 1 CUP filter
basket, you should extract approx. 30ml. When
using a 2 CUP filter basket, you should extract
approx. 60ml.
TEXTURING MILK
Different brands and milk alternatives will
texture differently. For best texturing results it
is recommended to use full cream milk when
using dairy milk and use barista type milks
when using plant-based milks. You may need to
adjust the froth level accordingly. Start with cold
milk. Fill milk jug to below the spout position. Lift
EN
13