Daily Inspection; Servicing And Maintenance Personnel Training And Qualification - Linde 1131-02 Series Original Instructions Manual

5
Maintenance
General Maintenance Information
The forklift must undergo functional testing
and a trial run after each inspection.
Service plan
Maintenance work must be carried out accord-
ing to the maintenance checklist.
The service plan is followed by advice to facili-
tate work.
Maintenance intervals must be reduced if the
truck is used under harsh conditions (extreme
heat or extreme cold, large quantities of dust).
Grade and quantity of lubricants and
other consumables
Only lubricants and other consumables speci-
fied in these operating instructions are author-
ised for use during maintenance work.

Daily inspection

This chapter describes pre-shift checks before
putting the truck into operation.
Daily inspection is effective to find the mal-
function or fault on this truck. Check the truck
on the following points before operation.
Remove load from truck and lower the forks.
CAUTION
Risk of injury.
Don't use the truck if any malfunction is found.
Check for scratches, deformation or cracks.
●
Check if there is any oil leakage from the
●
cylinder.

Servicing and maintenance personnel training and qualification

Truck maintenance must only be carried out
by qualified and authorised personnel.
The annual inspection for prevention of acci-
dents at work must be carried out by a person
qualified to do so. The person carrying out this
inspection must provide their expertise and
opinion without being influenced by economic
60
Lubricants and other consumables required
for truck maintenance are listed in the mainte-
nance specifications table.
Never mix different qualities of grease or oil. If
it is absolutely necessary to change brands,
make sure to flush thoroughly beforehand.
Before changing any filters or working on the
hydraulic system, thoroughly clean the surface
and the areas around the part.
All containers used to pour oil must be clean.
Check the vertical creep of the truck.
●
Check the smooth movement of the wheels.
●
Check the function of the emergency brake
●
by activating the emergency button.
Check, the tiller arm- switch braking func-
●
tion
Check the lifting and lowering functions by
●
operating the buttons.
Check if all bolts and nuts are tightened
●
firmly.
Visual check if there are any broken hoses
●
or broken electric wires.
factors or company internal issues. Safety is
the only critical deciding factor.
The person responsible for carrying out the in-
spection must have sufficient knowledge and
experience to be able to assess the condition
of the truck and the efficiency of the protective
installations in accordance with the technical
Operating Instructions - 1131 801 1601 EN - 12/2021 - 04